Welcome to ACME Mowersports, your best choice for Mower racing parts.
Acme Mowersports Corsicana, Tx. 903-875-9087 Acme is now an ARC dealer so we will be adding ARC parts to the website if you know of something you want from ARC give me a call or email and I will get you a price. Please feel free to call for info from 8:00 am until 8:00 P.M. Central time. Monday thru Saturday
Store Index 1
Home Page
Contact Us Page 1
Shopping Cart
How to mount a front axle
How to install a jackshaft setup
How to do direct steering
How to build a clutch
How to do wiring
IMOW Pulleys
How to do belt guides
vinyl lettering
Starter push button
Tethered kill switch
Basic wiring kit
Electrical Parts
USLMRA
ARC flywheel 6609
ARC Flywheel 6611
Favorite Links
700 tranny kit
Battery Terminal Covers
Wire end covers
Large cable end cover
How to remove a pulley
Red V Belts
8" 4 on 4 wheels
Throttle kit
ARC Rods
ARC Brass Syncro substitute weights
Starters and Parts
Rod end
Female rod end
Headgasket
Douglas Front Wheels
Wheels and hubs
Noram Clutch
Centrifugal Clutch
700 tranny kit 1 1/4" setup
Complete Kits
4 on 4 Steel wheels
MCP fluid brake system
MCP master cylinder rebuild kit
Rebuild kit for MCP caliper
MCP brake pads
How to mount a front axle

This will help you to mount your front axle whether you build it yourself or buy one that the guys are building.
When ever possibl move the front axle support close to your new axle.
After removing your old axle, get your new axle and measure to the center and mark a line on the axle beam
You will need 2 clamps, drill with either 3/8” or ½” drill bit depending on your bolt size you decide to use. I recommend ½” just for strength and locknuts. Depending on the space you have to fill either use a plate or washers to make up the thickness to fill the space. If you use washers tape them on the beam where you are going to clamp the axle, if you use a plate tape it onto the beam where you are going to want it when the axle is mounted so that you can drill hole thru it also. Slide the axle up in the frame lining the line in the center of the hole in the frame and clamp axle in place. Now drill your hole thru from front to back, if you used a plate install bolts and tighten, if you used washers remover the axle and tape the washers over the holes and put back in place, install bolts and tighten. You have now installed your front axle.